Timing belt complications usually occur without warning. There are no signs of obvious impending damage like an abnormal noise or leaks that could help alert you. Moreover, if your car suddenly dies during its run and refuses to restart, it is most likely that your timing belt is damaged and a timing belt replacement is needed.
Most car owners enjoy the benefit of having a car. The only downfall for such is the responsibility of maintenance in order to make it last for a long time. The car’s belt is among the most essential parts of the car as it works as a linkage between the crankshaft and camshaft. It controls the opening and closing of the valves located in the engine of the car. Naturally, if the belt gets damaged, the car will fail to run smoothly and safely.
Keeping the timed motion of a car is important. Failing to do so will result to a collision between other car parts such as the valves, cylinder head, cylinder walls and pistons. The belt, then, was made to prevent such incident from happening. The belt syncs the mechanism of the engine every time the car is in motion. It rests on two crankshaft pulleys and each of these contain a timing mark. It is important that these marks are arranged according to the timing specifications of the car. The pulleys are then toothed to prevent the belt from slipping off or sliding around the pulleys. These are all commonly preserved movements that help in the successful running of the car.
Because the belt is made from rubber, it is prone to stretching and breaking due to too much heat. As heat penetrates to the belt, it stretches and deteriorates causing the teeth of the belt to wear out. If there are no teeth to secure the belt, a collision of car parts is made possible. In order to prevent this from happening, a regular check-up or inspection must be done by a certified mechanic. Prevention is better than the cure as this would lessen the cost of car repair and maintenance.
Furthermore, preventing the belt from breaking can’t be done, a replacement remains as the only solution. It is recommended that the car’s timing belt is replaced every 50,000 to 70,000 miles. This is, however, dependent on the car’s replacement intervals for timing belts. This auto repair service usually costs between $250 and $750. Your expenses will vary according to the condition of the belt’s damage.
To save on costs, most car owners resort to replacing the belt on their own. Although it is a difficult task, it is not impossible to do. Experience and knowledge are, nevertheless, essential to have a successful replacement. It should be remembered that once the replacement is done incorrectly, your engine will not run. To avoid this, asking advice and recommendations from certified mechanics is a good measure. Researching is also logical to ensure more understanding regarding the replacement of timing belts.
Vancouver Auto Repair does the finest service in timing belt replacement in Vancouver, Burnaby, New Westminster, Delta, Surrey, North Burnaby, Coquitlam that will keep your car in good condition. Take advantage of their certified mechanics that will do the replacement accurately.